In the dog house

in the doghouse

  • Are you in trouble with the wife or girlfriend again?
  • Do you want to get back in her good books?
  • We have some ideas to help you put a smile back on her face!
  • Gifts – perfume, clothes, flowers, jewellery, sex toys and lots more
  • Romantic breaks – information on some of the best destinations for that romantic break
  • DIY – are you getting grief for that shelf or door you still haven’t put up?  Get  tips on how to do the most common DIY jobs

How to fix items to walls

Tools for the job


Hammer Drill      Protective Clothing   Scew Drivers


Pipe Detector            Drill Bits              Spirit Level


Step Ladder           Wall Plugs               Bradawl


Do you need nails or screws?

  • Usually you’ll only need picture hooks for a picture or a mirror with a frame. These come in a range of sizes and are simply hammered into the wall. The nails will go into most surfaces including brick.
  • But for a large picture or mirror with a heavy frame you’ll have to put screw fittings into the wall. Shelves and curtain poles supporting heavy curtains also need screw fittings

The right fitting for the right wall

  • The type of screw fitting you need depends on the construction of the wall you’re attaching an item to. The walls are likely to be plasterboard, brick or breeze block.
  • Tapping on the wall should tell you how it’s constructed. A hollow sound suggests the wall is plasterboard. A solid sound suggests brick or breeze-block

Check the wall BEFORE you drill

Before drilling, check there aren’t any water pipes or electricity cables behind the wall. For peace of mind use a detector to scan the wall. You’ll hear an alarm if it finds anything behind the plaster.


Types of wall plugs

  • You’ll usually need to use a wall plug to enable the screw to grip into the wall. There’s a wide range of wall plugs to match different screw sizes and types of wall.
  • Wall plugs for brick walls create a very tight fit once the screw has been inserted.
  • A universal plug is better for a lightweight block wall because it expands and digs into the soft block as the screw tights.
  • Plugs for hollow plasterboard walls are designed to give additional grip as the screw tightens. If the hollow wall is supported by timber stud work, you may be able to screw directly into these timbers.

Drilling holes for screws

  • For a plasterboard wall, make sure you choose the correct size masonry drill bit. You’ll need to drill all the way through to the cavity. Don’t push too hard on the drill or you could damage the wall as the drill goes through.
  • For a brick wall, once again select the right masonry drill bit. Use a piece of masking tape to mark the length of the wall plug and to show how deep to drill.
  • Set the drill to the hammer setting. Apply firm and steady pressure to your drill, making sure you’re at right angles to the wall’s surface.
  • Once the holes are drilled, insert the wall plugs. They may need a light tap with a hammer until they’re flush with the wall’s surface.